Factory-direct-hardware Hansgrohe 39148 Manual do Utilizador descarregar pdf (Página 3)

Installation

Remove the inserts from the plaster shields.

Trim the plaster shields to 1/16” from the finished

wall.

Seal the wall around the plaster shields with

waterproof sealant.

Lever handle model (39148XX1) only: Use a

17 mm deep socket wrench to remove the cartridges

from the rough-in. Install the new ¼ turn ceramic

cartridges included with the trim kit. The new hot

cartridge is marked with notches on the wrench flats.

All models: Remove the plug from the spout port.

Install the handle slip coupling. Use a ruler to measure

a point on the coupling 3/8” from the surface of the

finished wall. Mark the coupling at that point. Cut

the coupling. Insert the extension spindle.

1 2 3 4 5 6 7 8

Sem comentários

Factory-direct-hardware Hansgrohe 39148 Manual do Utilizador Página 3